Hello Support team - May I know why DAI is not updating the steps automatically.
At first, I couldn’t understand this message when I was trying to run a test config.
Custom scripted test case has 1 steps but the original scripted test case has 2 steps. The number of steps for both custom and original scripted test case should be equal.
After some checking in each area, found this.
I have couple of tests; each test has 2 steps inside which I created under Test Cases section. Then I pulled and added under a Test Config.
Later I have added one more step in the test case and tried to run, got the above message. Upon checking, DAI test config is not automatically getting updated with those new steps added after test config initially created but if you open the settings panel for each test case under config, it shows Refresh Panel. Upon clicking this, it pulls the latest steps to save.
Not sure why It is like this. I have to go to each test case under config to update like this if I have any changes to the test case. It not automatically updates with new steps.